A Forum reader recently asked:
"I'm looking to push GroupWise Messenger to several employee workstations. I'm trying to make the process as automated as possible."
And here is the response from Patrick Farrell ...
1. Edit the setup.cfg file.
2. Fill in the ServerAddress (you can put a DNS or IP address in) ServerPort (8300 by default).
3. At the bottom of the file, under ShowDialogs, set the following data:
This is for version 1.x. I haven't gotten around to moving to 2.x, but I would imagine it's very similar.
E. Neaves adds:
I found out the hard way that you also may have to modify
Otherwise, you still get the Language prompt.
Disclaimer: As with everything else at Cool Solutions, this content is definitely not supported by Novell (so don't even think of calling Support if you try something and it blows up).
It was contributed by a community member and is published "as is." It seems to have worked for at least one person, and might work for you. But please be sure to test, test, test before you do anything drastic with it.