A Forum reader recently asked:
"I have an old Apache Tomcat 4.0.6 server that runs behind iChain. Sometimes it stops responding if I call it through iChain. But it still runs fine if I call it directly with the localhost address. It seems like iChain doesn't have any connection to Tomcat. If I restart my Tomcat service, all things are good until it runs out again. I'm not a network expert or Ichain expert - maybe it's just a configuration setting that prevents Tomcat from releasing the connection?"
And here's the response from Ryan Seale ...
I run a few applications behind iChain on Tomcat and JBOSS. I run a password application, NetStorage, and Extend on JBOSS.
The only things I've done on iChain in the configuration is to go into the management configuration, enable the PIN list, and set the Tomcat accelerator addresses to "bypass".
There are a few troubleshooting things you can try. When you notice the problem, try purging your iChain cache from the Actions page. This will give you an idea if turning off caching on the accelerator will fix it.
If this fails, I would unlock the console and go into debug mode. From there, you can try pinging the Tomcat box. It will allow you to ping port numbers too; this is pretty helpful in establishing if you're being rejected for some reason. If so, you may want to change the
number of connections or the timeout/keep-alive settings on the Tomcat box.
Disclaimer: As with everything else at Cool Solutions, this content is definitely not supported by Novell (so don't even think of calling Support if you try something and it blows up).
It was contributed by a community member and is published "as is." It seems to have worked for at least one person, and might work for you. But please be sure to test, test, test before you do anything drastic with it.