Novell Home

emBox and Tree Merge

Novell Cool Solutions: Tip
By Jim Henderson

Digg This - Slashdot This

Posted: 21 Jun 2006
 

Problem

A Forum reader asked the following question:

I'm looking for clarification in the instructions for using emBox to do a tree merge. iManager is not an option for our situation at this point.

Specifically, in the documentation section titled "Using the eMBox client to merge trees" step 1 says to run the embox client. But it doesn't say which tree/server should be running the client. Should I run eMBox on a server in the target tree or the source tree? Does it even matter which one runs it?

And here's the response from Novell's Jim Henderson ...

Solution

It doesn't matter. Start edirutil with a -i and then log in. (Make sure you use a valid interface and port combination - I was trying 127.0.0.1 and wasn't connecting - eDir 8.8 doesn't bind to the loopback interface by default, so I couldn't get a connection on my Linux box). Do this:

login -s serverip -p port -u admin.context.whatever -w password

If you use the cleartext port, add a "-n" in there.

Then run this:

list -t dsmerge

This will give you the parameters that need to be passed to the tool. It states in the parameters which ones are used for the source and which are used for the target.

I strongly recommend health checks before and afterwards. If you visit the Cool Solutions pages, there's an article I wrote on using iMonitor to perform health checks that will help you do this step. See:
http://www.novell.com/coolsolutions/feature/15336.html


Novell Cool Solutions (corporate web communities) are produced by WebWise Solutions. www.webwiseone.com

© 2014 Novell