2.22 Serial Port Test Setup

Test Overview: This test is only required for systems with serial ports. This test is not part of the XEN tests. This test can be run independently from all other tests.

Test Objective: Verify the Serial Port functions in the system.

IMPORTANT:When assigning IP addresses to the NICs, do not use the range 192.168.101.0 through 192.168.101.255. These IP addresses are used in the Serial Port Test.

  1. Connect the SUT serial port 1 and FS4 serial port1 via a serial crossover (or Null Modem) cable.

    NOTE:Com port 1 must = 3f8 IRQ4

  2. Double-click Enable Serial Port 1 Test in the TestConsole project for the SUT.

  3. Double-click the Serial Port 1 Test to begin the test.