Upgrading from the Workflow Driver to the Manual Task Service Driver

You can install the new driver shim without affecting the existing Workflow Driver shim and configuration.

1. Use the Nsure^TM Identity Manager 2 installation to install the Manual Task Service Driver.

   You now have two sets of jar files, with the old names and new names.

   At this point, your existing driver configuration continues to work as it did before, using the Workflow Driver, because it points to the old version of the .jar files and the workflow_files directory.

   If you want to use the new Manual Task Service Driver with your existing driver configuration, continue with the remaining steps in this procedure.

2. Change the driver module name in the existing driver configuration:

   • Previous name: com.novell.nds.dirxml.driver.workflow.driver.WorkflowDriver
   • New name: com.novell.nds.dirxml.driver.manualtask.driver.ManualTaskDriver

   The following figure shows where to change the name. This item is the first driver parameter on the DirXML tab under Driver Configuration.

   
   

3. (Optional) Change the value of the driver parameter named Document Directory to use the new Manual Task directory.

   1. Change the directory the driver configuration is pointing to.

      The location of this directory is platform-specific.

      For example:

      • Previous value: C:\Novell\NDS\workflow_files
      • New value: C:\Novell\NDS\mt_files

   2. Make sure that any driver customization that you previously made to the workflow_files directory is also made to the new mt_files directory.

      For example, if you have customized a template such as the e-mail template in that directory, make sure the same change is in the new mt_files directory as well.