In general, there are three reasons for restriping of software RAID 0 and 5 devices:
Partition Replacement: If a partition fails, you must replace it. Restriping can recover the data in a single lost partition in a RAID 5 by using parity. However, the data must be restriped from a backup tape if a partition fails in a RAID 0.
RAID Expansion: If you expand a RAID 1 or 5 device, the RAID restripes the data across all members.
RAID Stripe Size: If you increase or decrease the stripe size of a RAID 1 or 5 device, the RAID restripes the data across all members. This happens infrequently, unless you are measuring performance with different striping sizes to determine which best fits your operational needs.
If the restriping process is interrupted, the RAID recognizes that when the system reboots, and automatically continues the restriping process. You can also use iManager to pause and resume a restriping process.
To manually resume or pause the Restripe process:
In iManager, click .
For instructions, see Section 3.1.6, Accessing Roles and Tasks in iManager.
Select a server in the eDirectory tree where you are logged in.
For instructions, see Section 3.1.7, Selecting a Server to Manage.
Make sure that there is no I/O for the volumes on the RAID device by deactivating the volume.
Click .
Select the volumes in the RAID device you want to expand.
Click (NetWare) or (Linux).
Select a device in the Software RAID Devices list.
Wait for the page to refresh before continuing.
Click .
The restriping process begins or pauses immediately. Restriping severely degrades I/O performance until the restriping is complete.