6.0 Viewing or Updating Device Details

After a device is discovered, its details are listed in ZENworks Control Center, based on the information available for a discovered device. For example, if the SNMP information is not available for a discovered device, then the SNMP Information panel is not displayed.

If the discovered information for a device is incorrect or insufficient, administrators with the Edit Discovered Device rights can manually change the details for the fields that have the Edit button next to them. However, except for the Asset information, manually updated information is overwritten with the discovered information when a discovery is run again for the same IP address.

You can view the following information about the discovered device:

To view or update the device details:

  1. In ZENworks Control Center, click Devices > Discovered.

    Figure 6-1 Discovered panel (Devices tab > Discovered page)

  2. In the Discovered panel, click a device type, then click a discovered device for which you want to view or update the details.

    The Details page lists information about the discovered devices.

  3. (Conditional) If the discovered information for a device is incorrect or insufficient, click Edit, then manually change the details for the fields.

    Your manual changes are overwritten the next time a discovery is run for this device.