System Variables

The System Variables panel lets you define variables that can be used to replace paths, names, and so forth as you enter information.

You can define system variables at three levels:

  • Management Zone: The system variables are inherited by the following: device folders, devices, and bundles.

  • Device Folder: The system variables are inherited by all devices contained within the folder or its subfolders.

  • Device or Bundle: The system variables apply only to the device or bundle for which they are configured.

The following table lists the tasks you can perform to manage the system variables:

Task

Steps

Additional Details

Add a variable

  1. If you are configuring system variables for an object (not for the entire Management Zone), click Override settings to activate the System Variables panel.

  2. Click Add, provide the name and value for the variable, then click OK.

  3. Click Apply.

When configuring system variables for an object, you can override an inherited variable by defining a new variable with the same name but a different value. For example, if Var1=c:\ is inherited, you can override it by defining Var1=d:\.

Variable names cannot include spaces and must be unique at the level where they are defined. For example, you cannot have two variables named Var1 defined at the device level (unless one is inherited, in which case the device level variable overrides the inherited variable).

Variable values cannot include the characters & and <.

Remove a variable

  1. Select the check box next to the variable (or variables).

  2. Click Remove.

  3. Click Apply.

 

Edit a variable

  1. Select the check box next to the variable.

  2. Click Edit.

  3. Modify the Name and Value fields as desired, then click OK.

  4. Click Apply.

Variable names cannot include spaces and must be unique at the level where they are defined. For example, you cannot have two variables named Var1 defined at the device level (unless one is inherited, in which case the device level variable overrides the inherited variable).

Variable values cannot include the characters & and <.

Use a variable

  1. Use the following syntax:

    ${VAR_NAME}

    Replace VAR_NAME with the name of the variable.

 

For trademark and copyright information, see Legal Notice.