This segment does not have an RMON Agent connected to it

Source:  ZENworks for Servers; Management and Monitoring Services; Traffic Analysis

Explanation:  The segment is not an Ethernet, token ring, or FDDI ring segment, or an RMON agent is not installed on the segment.

"Segment Not Monitored" has the same meaning as this message.

Action:  If you want the Ethernet, token ring, or FDDI ring segment to be monitored, install the Traffic Analysis Agent for NetWare or the Traffic Analysis Agent for Windows NT on a server on the segment.

Resolving Server Memory Problems

To free up server memory temporarily (until you can add more memory to the server), do one or more of the following:

• Use the FILER or the ConsoleOne utility to purge deleted files on the specified directory that cannot be purged automatically. (Deleted files are using up directory table space.).
• Use the REMOVE DOS or the SECURE CONSOLE commands to free the memory in the server that was reserved for DOS.
• Unload NetWare Loadable Module^TM (NLM) file programs, such as INSTALL or MONITOR, that are not currently needed.
• Dismount volumes that are not being used.
• Reduce the size or number of volumes that the server supports.
• Delete unused files and directories on the specified volume.
• As a last resort, back up all files in your volume, bring down your server, and use the INSTALL command to reinitialize the volume. Specify a block size of 64 KB and turn the Block Suballocation option to OFF. (This setting uses a lot of disk space but increases the amount of memory available.)
• Change the Minimum File Delete Wait Time SET parameter in the AUTOEXEC.NCF file so that files can be purged immediately rather than being retained in a salvageable state on the volume.

For servers running NetWare Management Agent 2.1:

1. Select View > All > NetWare File Servers.

2. Double-click the specific server.

3. Select Configure > Set NetWare Server Parameters.

4. Select the File System parameter.

5. Change the parameter so that files can be purged immediately by selecting the AUTOEXEC.NCF check box listed in the Set From section of the dialog box.

For servers running NetWare Management Agent 1.5/1.6, use Remote Console (Tools > Remote Console) to change server parameters.