For a Dynamic File Services pair, you can specify one or more folders in the pair’s primary path that you want to include or to exclude from the policy runs. For a given pair, you can include folders, or you can exclude folders, but not both. The Include/Exclude setting should be set on subfolders and not the root of the primary path.
IMPORTANT:The primary path must reside on a device that is attached to the Dynamic File Services server. The Include/Exclude option does not support remote primary paths.
The Include/Exclude setting applies only to the policies for the pair that are run against the primary path. That is, the Include/Exclude feature applies to policies that are moving data with a
setting of .In the Management Console, connect to the DynamicFS server that you want to manage.
Right-click the pair that you want to manage, then select
to open the Pair Properties dialog box.Select the
tab.In
, select only one of the following restriction options per pair:The options are dimmed and not selectable if the pair has a remote primary path.
None: The
option is disabled for the pair. Existing paths in the list are not deselected, and remain available if you later re-enable or .Exclude: Enable the
option. Policies that run on the primary path (primary to secondary) do not act on content in the specified folders on the primary path.Include: Enable the
option. Policies that run on the primary path (primary to secondary) act only on content in the specified folders on the primary path.Create a list of folders where you want to apply the
setting when it is enabled.Click
to open a file browser dialog box.Select the check box next to a folder to add it to the list.
Click
to return to the tab.On the
tab, click to save and apply the changes.In the following example, the C:\primary1\includeme folder.
setting is enabled. Primary-to-secondary policies apply only to the(Optional) Remove folders from the
list.Click
to open a file browser dialog box.Deselect the check box next to a folder to remove it from the list.
Click
to return to the tab.On the
tab, click to save and apply the changes.Click
to save your changes and close the Pair Properties dialog box.