Click
under .Click
, then click .Specify your firewall configurations.
External Interface: The network interface connected to the Internet.
Internal Interface: The internal network interface. If you are using NAT, it will route from the external interface to the internal interface.
NAT: Network Address Translation shares the firewalled internet connection with the network on the internal network interface. This is a must if you are using this server as your network firewall.
Specify your firewall port setup. See Section 1.4, Planning for the NOWS SBE Install for typical ports that should be open for TCP and UDP.
Additional Ports (TCP): Specify a comma-separated list of additional TCP ports to open on the firewall. Port ranges can be specified with a hyphen.
Additional Ports (UDP): Specify a comma-separated list of additional UDP ports to open on the firewall. Port ranges can be specified with a hyphen.
Review the settings. To make a change, click
. To proceed with the installation, click .The firewall install is complete. Click
to proceed to the available software page. Firewall is now listed on the installed software list.