Agent Features

The ZENworks® Adaptive Agent uses modules to perform the following functions on managed devices:

By default, all modules are installed on a device. However, you can uninstall any of the modules. You can also disable (or enable) any of the installed modules.

Depending on many factors, when you uninstall or disable a module, the setting might not take effect immediately. If you uninstall or disable a module while it is performing a task, the module is not uninstalled or disabled until the task is complete. For example, if you disable the Bundle Management module while a bundle is being applied to the device, the module is disabled after the bundle is applied. Also, if a device is running a Dynamic Local User (DLU) policy, the Policy Management module cannot be disabled or uninstalled until the user logs out.

You can install, uninstall, enable, or disable the modules at three levels:

To modify a module’s state:

  1. (Conditional) If you are configuring the ZENworks Agent settings on a device folder or a device, click Override settings.

  2. To install a module, select the Installed check box.

    or

    To uninstall a module, deselect the Installed check box.

    By default, the Installed check boxes for all modules are selected, meaning that all modules are installed on devices when they register to your ZENworks Management Zone. If you deselect a module’s Installed check box, that module is uninstalled from the device the next time it refreshes.

  3. To enable an installed module, click the Enabled button.

    or

    To disable an installed module, click the Disabled button.

    By default, the Enabled option for all installed modules is selected, meaning that all modules are enabled on devices. Disabling a module does not cause that module to be uninstalled from currently managed devices. The module remains installed on the device, but it is disabled.

  4. Specify the reboot behavior if a reboot is required.

    This option applies only when installing or uninstalling a module. In some cases, Windows Installer might require a reboot of the device when installing or uninstalling the module. If a reboot is required during install, the module does not function until the reboot occurs. If a reboot is required during uninstall, the module’s files are not completely removed until a reboot occurs, but the module stops functioning.

    • Prompt user to reboot (Default): The user is prompted to reboot the device. The user can reboot immediately or wait until later.

    • Do not reboot device: No reboot occurs. The user must initiate a reboot.

    • Force device to reboot: The device is automatically rebooted. The user is notified that the device will reboot in 5 minutes.

  5. Click Apply to save the changes.

For trademark and copyright information, see Legal Notices.