Novell Home

My Favorites

Close

Please to see your favorites.

How to put BorderManager default filters back in place.

(Last modified: 10Feb2003)

This document (10013153) is provided subject to the disclaimer at the end of this document.

goal

How to put BorderManager default filters back in place.

How to reset BorderManager filters.

fact

Novell BorderManager 3.5

Novell BorderManager 3.6

Formerly TID 2930904

fix

Steps to reset BorderManager filters:
     1) Unload IPFLT, IPXFLT, AND FILTSRV at the console.
     2) Disable filter support in INETCFG/PROTOCOLS/TCPIP and IPX.
     3) Rename the SYS:ETC/FILTERS.CFG.
     4) Reinitialize system.
     5) LOAD BRDCFG.NLM.
     6) Say NO to launch INETCFG.NLM.
     8) Select Set filters on the Public interface.
     9) Select the PUBLIC interface and enter on continue.
     10) Hit ENTER when prompted to acknowledge both IP and IPX filter placement success.
     11) Hit ESCAPE to leave BRDCFG.NLM. The system will be reinitialized automatically.

disclaimer

The Origin of this information may be internal or external to Novell. Novell makes all reasonable efforts to verify this information. However, the information provided in this document is for your information only. Novell makes no explicit or implied claims to the validity of this information.
Any trademarks referenced in this document are the property of their respective owners. Consult your product manuals for complete trademark information.

  • Document ID:
  • 10013153
  • Solution ID: 4.0.6634098.2248324
  • Creation Date: 26Jul1999
  • Modified Date: 10Feb2003
    • NovellNetWare

      BorderManager Services

Did this document solve your problem? Provide Feedback