ZENworks Diagnostic Probe Replacement

Notice the failure for ZENworks Diagnostic page to respond for the servers.
If the replacement of the ZENworks Diagnostic Probe is necessary or has been removed from ZCC.

Go to the latest System update that matches current installed zone version.
Download novell-zenworks-probe.11.4.1.msi
Extract novell-zenworks-probe.11.4.1.msi
Open ZCC > Diagnostics and update the zenworks-probe.war

Example v11.4.1 Zone

Locate the file for extraction
%ZENworks_Home%\work\content-repo\system-update\5011040100fc50000000002015121012\msi
Copy novell-zenworks-probe.11.4.1.msi to c:\Probe

Extract the .war file
Open Command Prompt (Run as Administrator)
Change directory to C:\Probe
msiexec.exe  /a  novell-zenworks-probe.11.4.1.msi  /qb  TARGETDIR=<DirLocation>

Deploy the Probe to the ZENworks Primary
Log into ZCC on the Primary server needing the Probe
Open ZCC > Diagnostics
Select Deploy Probe at the top of the ZCC Diagnostics page
Select Choose File and navigate to the extracted zenworks-probe.war file.

When completed ZCC should report Success:  Successfully deployed Probe on this server.

Every ZENworks Primary Server has a Diagnostic Probe.

ZENworks 11 SP4 Probe Documentation

ZENworks Diagnostic Probe doesn't load status for server - TID 7015481

After Changing Certificate or Disaster Recovery steps or system update ZENworks Diagnostic Page fails to load in ZCC - TID 7015138

FYI - version 11.4.1 and 11.4.2 use the same probe (novell-zenworks-probe.11.4.1.msi)