Novell Cool Solutions

Enabling the Debug Options in TSAFS on NetWare



By:

March 30, 2007 6:16 pm

Reads:10,157

Comments:0

Score:Unrated

Print/PDF

Steps for putting TSAFS.NLM into debug mode on NetWare.

Solution:

Enabling the debug options in tsafs:

  1. From the file server console type:
    TSAFS /smsdebug=fffffffc /smsdebug2=fffffffc

    This will put the TSAFS into debug mode.

  2. Run any backups or restores that you know will exhibit the bad behavior. A lot of data will be written to the debug log, so try to limit your tests or data sets to the minimum needed to exhibit the problem.
  3. Then turn off the debugging by typing at the file server console:
    TSAFS /smsdebug=0 /smsdebug2=0	
  4. Collect the debug log at sys:/system/tsa/tsadbg.log and send it in for analysis.
0 votes, average: 0.00 out of 50 votes, average: 0.00 out of 50 votes, average: 0.00 out of 50 votes, average: 0.00 out of 50 votes, average: 0.00 out of 5 (0 votes, average: 0.00 out of 5)
You need to be a registered member to rate this post.
Loading...Loading...

Categories: Uncategorized

0

Disclaimer: This content is not supported by Novell. It was contributed by a community member and is published "as is." It seems to have worked for at least one person, and might work for you. But please be sure to test it thoroughly before using it in a production environment.

Comment

RSS