Novell Cool Solutions

LUM-enabling pure-ftpd: Quick and Easy



By:

April 2, 2009 4:36 pm

Reads:10,523

Comments:0

Score:5

Print/PDF

LUM-enabling pure-ftpd: Quick and Easy

By Darcy Partridge

Editor’s Note: This topic was previously touched on in a 2005 AppNote called “PAM Integration with eDirectory and LDAP.” However, much of that information is now obsolete, so we have removed the AppNote from Cool Solutions, and encourage you to read this TID for the correct approach.

Environment
Novell Open Enterprise Server 2 (OES 2)
Novell Open Enterprise Server 1 (OES 1) Support Pack 2 Linux
pure-ftpd (an FTP server)

In OES (Linux), depending on the version of OES and the Install / Configuration options used, pure-ftpd may not already be LUM enabled, and in some cases there may not be an option in YaST to accomplish that. However, this is very easy to accomplish. Other documents have been published on this subject, but sometimes take more difficult routes, or spend a lot of time covering the underlying technology or theories. This unfortunately can make it sound much more difficult than it actually is.

For those already familiar with pure-ftpd in a SUSE Linux environment, there is only a couple of steps needed. But additional points will be discussed here for those who are not already familiar with pure-ftpd, Linux, or OES, and to cover commonly-encountered problems.

For complete details, read TID 3503915.

1 vote, average: 5.00 out of 51 vote, average: 5.00 out of 51 vote, average: 5.00 out of 51 vote, average: 5.00 out of 51 vote, average: 5.00 out of 5 (1 votes, average: 5.00 out of 5)
You need to be a registered member to rate this post.
Loading...Loading...

Categories: Uncategorized

0

Disclaimer: This content is not supported by Novell. It was contributed by a community member and is published "as is." It seems to have worked for at least one person, and might work for you. But please be sure to test it thoroughly before using it in a production environment.

Comment

RSS