Novell Cool Solutions

SATA Mode Not Supported By Hard Drive Image Software



By:

June 15, 2007 2:07 pm

Reads:6,012

Comments:0

Score:Unrated

Print/PDF

PROBLEM: “SATA Mode Not Supported By Hard Drive Image Software” HP D530 Take a look on the HP Website. You will find there a customer advisory –> DB030507_CW01 revision 1 (released February 2004) from this old article.

SOLUTION: In the CMOS Settings you might encounter Drive configuration settings for Parallel ATA (Both)
Serial Ata (Enabled) Primary (Auto). If the Parallel ATA isn’t set to Both, you may encounter the mode issue. You may also have to update your ZENworks Patch or your Kernel on the machine you used for creating your imaging CDs or diskettes so that it has more current HDD (and network) drivers.

If you have any questions you may contact CJ at goggincj@TAKETHISOUTpgcc.edu

0 votes, average: 0.00 out of 50 votes, average: 0.00 out of 50 votes, average: 0.00 out of 50 votes, average: 0.00 out of 50 votes, average: 0.00 out of 5 (0 votes, average: 0.00 out of 5)
You need to be a registered member to rate this post.
Loading...Loading...

Categories: Uncategorized

0

Disclaimer: This content is not supported by Novell. It was contributed by a community member and is published "as is." It seems to have worked for at least one person, and might work for you. But please be sure to test it thoroughly before using it in a production environment.

Comment

RSS