Cool Solutions

Using a Secondary Domain with a GroupWise Client

Joe Marton


April 1, 2008 7:31 am






A Forum reader recently asked:

“Is it possible to change the sender-domain for the GroupWise client?

For example:

standard address:
second address:

This is because a customer works for two organizations that are both in the same GroupWise system, and the goal is to be able to send with either address.”

And here is the response from Joe Marton …


If they want to send as both addresses, then they’ll have to create a bogus POP/IMAP account to do this. If Internet Addressing for the users is configured for, then they’ll need to create a bogus account for Then when they go to send an e-mail they can choose the from address for sending the mail.

Just make sure that IA is configured in your GW system to allow both iDdomains, or else replies to this secondary one will get bounced back.

0 votes, average: 0.00 out of 50 votes, average: 0.00 out of 50 votes, average: 0.00 out of 50 votes, average: 0.00 out of 50 votes, average: 0.00 out of 5 (0 votes, average: 0.00 out of 5)
You need to be a registered member to rate this post.

Categories: Uncategorized


Disclaimer: This content is not supported by Micro Focus. It was contributed by a community member and is published "as is." It seems to have worked for at least one person, and might work for you. But please be sure to test it thoroughly before using it in a production environment.