| |
To configure NetWare Link/ATM WAN call destination parameters, complete the following steps:
Load NIASCFG, then select the following parameter path:
Select Configure NIAS > Protocols and Routing > WAN Call Directory > Press Ins
Type the new WAN call destination name.
Select ATMWAA from the supported wide area media list.
In the Call Type field, accept Permanent or press Enter to select On Demand.
In the Interface Name field, select the logical board name used for this ATMWAA interface.
In the Connection Type field, accept SVC or press Enter to select PVC.
When you set the connection type to SVC, you must enter a destination ATM address in the field provided.
When you set the connection type to PVC, you must enter a virtual connection identifier in the field provided.
In the PVC VCI field, for PVC connection type, enter the PVC identifier.
The PVC identifier consists of a 1-byte virtual path identifier, followed by a 2-byte virtual channel identifier.
The valid range is 0x000020 through 0xFFFFFF.
In the Destination ATM Address field, for SVC connection type, enter the destination ATM address.
In the Multiplex Protocols field, accept Yes or press Enter to select No.
In the Retry Mode field, accept Retry Self-Correcting Failures or press Enter to select another value.
In the Retry Limit Handling field, accept Continuous At Limit or press Enter to select another value.
In the Retry Interval Limit field, accept 00:10:00 or press Enter to enter another value.
In the Retry Line Timeout field, accept 00:10:00 or press Enter to enter another value.
In the Remote System ID field, enter the name of the target remote system.
In the Service Class field, accept UBR or press Enter to enter another value.
The service class specifies the service parameters to be used during connection setup:
ABR (Available Bit Rate)
VBR (Variable Bit Rate)
UBR (Unspecified Bit Rate)
In the Peak Rate field, accept the default value, or enter the value given by your ATM service provider.
In the Sustained Rate field, if service class is set to VBR, accept the default value, or enter the value given by your ATM service provider.
In the Minimum Rate field, if service class is set to ABR, accept the default value, or enter the value given by your ATM service provider.
In the Rate Adjustment field, accept Nearest or press Enter to select Nearest Lower.
This parameter specifies how the bit rate is rounded off when it is converting to cell rate.
In the Inbound Authentication Update field, accept Enabled or press Enter to select Disabled.
To exit this configuration procedure and save your changes, press Esq. and select Yes when prompted.
| |