| |
After you install and configure the remote access software, generate a configuration report to verify your port configuration and maintain server records. To verify the configuration, complete the following steps:
Select Generate Configuration Report in the Remote Access Options menu.
(Optional) Press F2 to display a list of report options that you can select (or deselect) to customize the configuration report.
Press the Up-arrow or Down-arrow key to highlight an option, and press Enter to toggle the option on (Yes) or off (No).
You are prompted for the output device.
Select the device you want to send the report to and press Enter.
Select Screen if you want the output to be displayed on the screen, or select Disk File if you want to view the entire contents later. The report is saved in the NWCRPT.TXT file in the SYS: volume. This file is overwritten each time you select this option. You can change the default pathname to create a different file.
The configuration report appears.
Check the entries in the report.
Make sure your configuration is set up properly by verifying the following:
The consistency check warnings are displayed at the beginning of the report. These warnings might display inconsistencies with port configurations and licenses.
This context represents the username display.
If you do not see the proper services loaded, refer to the instructions for loading the services.
Generate the report again if you made changes to the configuration.
| |