13.6 Verifying the Installation

Perform the following steps if you want to verify a successful installation.

After the installation has completed and the server has been rebooted, do any of the following to verify that ZENworks is running:
- Run ZENworks Control Center
  
  If ZENworks Control Center did not automatically start, use the following URL to open it in a web browser:
  
  https://DNS_name_or_IP_address_of_Primary_Server/zenworks
  
  NOTE:If the Primary Server is not using the default HTTPS port, you must add the port to the URL: https://DNS_name_or_IP_address_of_Primary_Server:port_number/zenworks
  
  This can be done either on the server where you just installed ZENworks, or on a qualified workstation.
- Check the Linux services by using the configuration command
  
  On the server, run the following command:
```
/opt/microfocus/zenworks/bin/microfocus-zenworks-configure ‑c SystemStatus
```
  This lists all ZENworks services and their statuses.
  
  To start the services, run the following command:
```
/opt/microfocus/zenworks/bin/microfocus-zenworks-configure ‑c Start
```
- Check the Linux services by using the specific services’ commands
  
  On the server, run the following commands:
```
systemctl status microfocus-zenserver.service
```
```
systemctl status microfocus-zenloader.service
```
  If the services are not running, run the following commands to start the ZENworks services:
```
systemctl status microfocus-zenserver.service
```
```
systemctl status microfocus-zenloader.service
```