6.5 Configuration Information
The WorkOrder driver configuration file is a sample configuration you customize to your environment. After the WorkOrder driver is installed, you must import and customize the driver configuration file in either Designer or iManager.
As you import the driver configuration file, you are prompted for certain information depending on the configuration selection you made. The following table explains the parameters you must provide during initial driver configuration.
Table 6-1 Configuring the Driver
Driver Name |
The actual name you want to use for the driver. |
WorkOrders Container |
The name of the container where work orders are to be stored. |
WorkToDo Container |
The name of the container to store configured work orders. |
Polling Method |
Specifies the polling method by interval or time. indicates that the driver will poll at a specified time interval. indicates a specific time of day. |
Driver Heartbeat |
Specifies if the Publisher should emit heartbeat documents. The driver emits heartbeat documents to indicate to the Identity Manager that the driver is still functioning. |
Install Driver as Remote or Local |
Select to configure the driver for use with the Remote Loader service.
Select to configure the driver for local use. |
Poll Interval |
The polling interval (in minutes) at which the Publisher channel polls the Identity Manager Vault for work orders to be configured. |
Poll Time |
Time of day the Publisher channel wakes up to check the Identity Manager Vault for work orders to be configured. |