This section describes how to install the Novell Linux Point of Service software and set up an Administration Server.
To install the Novell Linux Point of Service software on the Administration Server:
Start the YaST utility by inserting Novell Linux Point of Service 9 CD 1 into the drive and rebooting the computer.
At the SuSE boot screen, select
.Go through the rest of the initial installation screens as outlined in Section 2.5.1, Starting the YaST Utility.
When you get to the Installation Settings screen, make your settings as outlined in Section 2.5.2, The Installation Settings Screen.
For the
option, choose the software selection for the type of Administration Server you are installing:This selection installs all Administration and Branch Server packages to the server, but none of the Image Builder packages.
This selection installs all Administration and Branch Server packages to the server, plus the Image Builder components listed in Table 4-1.
Table 4-1 Image Builder components
When you have finished making your installation settings, click
.When prompted, answer Yes to start the installation.
YaST partitions the drive, applies the installation settings, and copies the necessary files from NLPOS CD 1 to disk.
When prompted, insert each requested CD, then click
.When it finishes with the basic installation, the system reboots and YaST starts again.
Continue through the screens as outlined in Section 2.5.3, The YaST Configuration Phase.
After you have completed the options in the Hardware Configuration screen, click
.Remove any CDs from the drive, and then click
to complete the installation.The system reboots.
Log in as root.
You are now ready to initialize the Novell Linux Point of Service LDAP directory.