This section contains the following information about the Access Gateway Appliance logs:
You can use the following procedure to set the level of information logged to the ics_dyn.log file in the /var/log directory.
At the command prompt, enter the following command:
nash
At the nash shell prompt, enter the following command:
configure .current
To change the log level, enter the following command:
log-conf log-level <log level>
Replace <log level> with the new log level that you want to set.
When you run the /etc/init.d/novell-vmc start command, the default log level is set to LOG_NOTICE. You can change the log level to any level from LOG_EMERG to LOG_INFO.
To apply changes, enter the following command:
apply
To exit from the configuration mode, enter the following command:
exit
To exit from the nash shell, enter the following command:
exit
The entries in the ics_dyn.log file have the following format:
<time-date-stamp> <hostname> : <AM#event-code> : <AMDEVICE#device-id> : <AMAUTHID#auth-id> : <AMEVENTID#event-id> :<supplementary log entry data and text>
A sample log message is given below:
Aug 3 14:35:41 c1h : AM#504503000: AMDEVICEID#ag-0BDF41AAC4CDCBE5 : AMAUTHID#0: AMEVENTID#74: Process request 1 'www.lag-202.com' '/AGLogout' [192.10.100.111:38091 -> 192.10.106.2:80]
The fifth and sixth digits in the <AMEVENTID#event-id> refer to the Access Gateway components. The following table list the numbers and the components which they denote.
Table 4-1 Linux Access Gateway Components
At the command prompt, enter the following command:
nash
To enter the configuration mode, enter the following command:
configure .current
Enter one of the following commands to configure logging:
To apply changes, enter the following command:
apply
To exit from the configuration mode, enter the following command:
exit
To exit from the nash shell, enter the following command:
exit