8.8 Adjusting a Discovered Product’s Installation Count

A discovered product provides a count of the total number of installations for the product. If necessary, you can manually adjust this count by ignoring installations or adding to the installation count.

  1. In ZENworks Control Center, click the Asset Management tab.

  2. In the License Management page, click Discovered Products.

  3. Click the discovered product whose installations you want to adjust.

  4. Click the Installations/Consumption tab.

    The Consumption panel displays the following information:

    Ignored Installations: The number of installations excluded from the total installation count (also referred to as the net consumption). You manually mark the installations you want ignored. See Step 5 for instructions.

    Recognized Installations: The number of installations included in the total installation count.

    Additional Consumption: The number of additional installations you want to add to the recognized installations. See Step 6 for instructions.

    Net Consumption: The total number of installations included in the discovered product’s installation count. This is equal to (Recognized Installations + Additional Consumption) - Ignored Installations.

  5. To ignore an installation, select the installation in the Installations panel by clicking the check box next to the installation, then click Action > Ignore Installation.

  6. To add installations to the count, use the Additional Consumption field in the Consumption panel to select the number of additional installations.

  7. Click Apply to save your changes.