If you are using SNMP, you should configure and enable this policy. You use this policy to establish the targets (or locations) where you want SNMP traps sent. Each target must be a valid TCP/IP address or DNS name.
To set up the SNMP Trap Targets policy:
In ConsoleOne, right-click the Service Location Package, then click
.The
tab is displayed.Select the check box under the
column for the SNMP Trap Targets policy.This both selects and enables the policy.
Click
.Click
, enter a new target, then click .Repeat Step 4 for each trap target you need.
Click
to save the policy.When you have finished configuring all of the policies for this package, continue with the steps under Section 14.5, Associating the Service Location Package to associate the policy package.