Configuring SAML and ConsoleOne

After you have configured the sample site and installed the SAML components, you are ready to configure the system.


Creating the SAMLExtensionServer

Follow the same steps you used for the iChainSite setup. For details, see Creating the SAMLExtensionServer.


Creating the ISO ProviderSiteID Link

For details on how to create the ISO ProviderSiteID link, seeCreating the ISO ProviderSiteID Link.


Creating the SAMLSiteConfig Object

Create a samlSiteConfig object by following the same steps you used for the iChainSite setup. For details, see Creating the SAMLSiteConfig Object. The setup parameters in this case are different than the ones you used for the iChainSite. Figure 35, shows the appropriate values:


General Page

For details on the General page, see General Page. Figure 35 shows the values that should be used for the eMartian site:

Figure 35
eMartian SAMLConfig: General Page

NOTE:  The Key Pair Information fields should be left blank at this point. See Fine-Tuning the SAML Extension for information on key pair management.


Assertions Page

For details on the Assertions page, see Assertions Page. Figure 36 shows the values that you could use for the eMartian setup:

Figure 36
eMartian SAMLConfig: Assertions Page


URLs Page

For details on the URLs page, see URLs Page. Figure 37 shows possible values for the eMartian application:

Figure 37
eMartian SAMLConfig: URLs Page