Use the -zenpart mode command to enable, disable, or remove the installed ZENworks partition.
To use the Help mode:
To display the ZENworks Imaging Engine menu, enter:
img
Click Partitioning, then click one of the following:
Disable ZEN Partition: Disables the ZENworks partition.
Enable ZEN Partition: Enables the ZENworks partition.
Remove ZEN Partition: Removes the ZENworks partition.
IMPORTANT:If you remove an installed ZENworks partition, you must immediately restore a base image with a valid non-grub MBR (Master Boot Record). If you do not, the device cannot boot properly.
Click Imaging > Exit to display the imaging maintenance mode prompt.
At the prompt, enter grub.s to make this change effective.
Using the imaging maintenance mode prompt, the following example explains the syntax and available parameters that you can use with the various ZENworks partition management mode commands:
img -zenpart operation
where operation is to disable, enable, or remove a ZENworks partition.
To manage a ZENworks partition:
From the imaging maintenance mode prompt, enter one of the following:
img -zenpart -disable
img -zenpart -enable
img -zenpart -remove
IMPORTANT:If you remove an installed ZENworks partition, you must immediately restore a base image with a valid non-grub MBR (Master Boot Record). If you do not, the device cannot boot properly.
Enter grub.s to make this change effective.