The Action - Delay dialog box lets you specify a system delay between two actions in the action set and the specific requirements that a device must meet for the action to be executed on the device.
Figure 6-6 Action - Delay Dialog Box
To access this dialog box in ZENworks Control Center, click the
tab. Click the underlined link of a bundle in the column of the list, click the tab, click one of the action set tabs (Distribute, Install, Launch, Verify, Uninstall, Terminate, or Preboot), click the drop-down list, then select an available action.The following sections contains additional information:
The General page lets you specify a system delay between two actions in the action set.
Specify the desired time delay, in seconds. After completing the action, the system delays for the specified amount of time before performing the next action.
Specify the processes or services that must start before the next action in the action set is performed.
To add a process or service to the list:
Click
to display the dialog box.Select notepad.exe or ${SystemRoot}\system32\notepad.exe.
, specify the process that must start before performing the next action, then click . You can specify either the name of the process or its full path. For example, you can specifyor
Select
, specify the service that must start before performing the next action, then click .Repeat Step 2 as needed.
Specify the maximum amount of time to wait for the process or service to start before performing the next action in the action set. If the process or service does not start in the specified amount of time, the next action is performed.
Click
.Click
to change a process or service, or click to delete a process or service.The Requirements page lets you define specific requirements that a device must meet for the action to be enforced on it. For information about the requirements, see Requirements.