Use global settings to configure the mapping of Administration Console(s) Private IP address to Public NAT IP address.
The devices that cannot reach the Private Administration Console IP address use the NAT IP address. You must specify the NAT IP Addresses prior to importing devices.
You can perform the following activities by using the following global settings:
To create new IP address,
Log in to Access Manager.
Go to
, then click .Select an IP address from the
drop-down list.Enter the Public NAT IP Address.
NOTE:If NAT IP address is not provided or if a mapping already exists for the selected Administration Console IP, IP Address is not valid message is displayed.
To continue, click
, then click .Click
to exit.To remove an existing IP address,
Log in to Access Manager.
Go to
, then select the IP address check box you want to delete.Click
, then click .To view the newly created and existing IP address,
Log in to Access Manager.
Go to
to view the list of already configured Physical IP addresses and NAT IP addresses.Create
if the list does not contain any and entries.Physical IP Address: Specifies the physical private IP Address for the Administration Console.
Public NAT IP Address: Specifies the Public NAT IP Address. You can configure or map the
.Click
.To edit the existing IP address,
Log in to Access Manager.
Go to
, then click on the Public NAT IP Address hyperlink.Enter the new Public NAT IP Address.
Click
to continue or click to exit.