| |
When you first install the Novell Internet Access Server 4.1 remote access software or when you add a serial adapter board, the automated setup procedure helps you configure your ports automatically. If you exited the automated setup without completing the port configuration, you must load the drivers manually.
To load the appropriate driver, complete the following steps:
Load NIASCFG, then select the following path:
Select Configure NIAS > Remote Access > Set Up... > Add a Serial Adapter Board
For each communications adapter you have installed, load its AIO driver once by selecting the appropriate serial adapter entry from the list.
If no AIO ports are defined or the board cannot be loaded, you see a warning message. Press Enter and step through configuring the board. Otherwise, skip to Step 5.
To configure a board, you must enter its name and other specific information. Follow the prompts on the screen.
Press Ins and select the WHSMCAPI driver for ISDN.
NOTE: Some ISDN boards, such as the US Robotics Allegra series for NetWare, use WAN ODI drivers instead of WHSMCAPI. Select the appropriate driver, or press Ins and use your manufacturer-supplied driver diskette. Specify your board parameters, then continue with Step 5.
Select Continue with Automated Setup after remote access has determined which ports have modems attached. Select Try Modem Discovery Again if modems were not discovered (not turned on).
| |