Novell Doc: NW 6.5 SP8: NSS File System Administration Guide - December 14, 2007

J.7 December 14, 2007

Updates were made to the following sections. The changes are explained below.

J.7.1 Installing and Configuring Novell Storage Services

Location	Change
Upgrading from OES 1 Linux to OES 2 Linux	This section is new. It addresses read performance problems you might experience for NSS volumes after upgrading from OES 1 Linux to OES 2 Linux.

J.7.2 Managing Backup and Restore for Data and Trustee Information

Location	Change
Using Extended Attributes (xAttr) Commands (Linux)	Procedures were added for enabling and disabling support for the Linux xattr API.

J.7.3 Management Tools for NSS

Location	Change
Understanding Storage-Related Plug-Ins	Added the paths and filenames of all storage-related plug-in files.

J.7.4 NSS Commands

Location	Change
Read Ahead Blocks and Allocate Ahead Blocks Commands	A note was added to address read performance problems you might experience for NSS volumes after upgrading from OES 1 Linux to OES 2 Linux.

J.7.5 Planning Your Multipath I/O Solution for NSS on NetWare

Location	Change
Planning Your Multipath I/O Solution for NSS on NetWare	You should set a non-zero priority on all of the paths for the device. If you set a non-zero priority on any of the paths, zero is considered the highest priority until all paths are set to a non-zero value.