E.7 ZENworks Partition Management Mode

Use the -zenpart mode command to enable, disable, or remove the installed ZENworks partition.

To use the Help mode:

E.7.1 Using the ZENworks Imaging Engine Menu to Manage a Partition

  1. To display the ZENworks Imaging Engine menu, enter:

    img
    
  2. Click Partitioning, then click one of the following:

    Disable ZEN Partition: Disables the ZENworks partition.

    Enable ZEN Partition: Enables the ZENworks partition.

    Remove ZEN Partition: Removes the ZENworks partition.

    IMPORTANT:If you remove an installed ZENworks partition, you must immediately restore a base image with a valid non-grub MBR (Master Boot Record). If you do not, the device cannot boot properly.

  3. Click Imaging > Exit to display the imaging maintenance mode prompt.

  4. At the prompt, enter grub.s to make this change effective.

E.7.2 Using the Imaging Maintenance Mode Prompt to Manage a Partition

Using the imaging maintenance mode prompt, the following example explains the syntax and available parameters that you can use with the various ZENworks partition management mode commands:

img -zenpart operation

where operation is to disable, enable, or remove a ZENworks partition.

To manage a ZENworks partition:

  1. From the imaging maintenance mode prompt, enter one of the following:

    img -zenpart -disable

    img -zenpart -enable

    img -zenpart -remove

    IMPORTANT:If you remove an installed ZENworks partition, you must immediately restore a base image with a valid non-grub MBR (Master Boot Record). If you do not, the device cannot boot properly.

  2. Enter grub.s to make this change effective.