5.0 CAPTURE Messages

The following messages include messages from the CAPTURE.EXE.

CAPTURE-X-163: This workstation does not have enough memory to run CAPTURE.

Source: CAPTURE.EXE
Possible Cause: This workstation does not have enough available memory. This utility requires a minimum of from 235 KB to 275 KB of memory.

NOTE:Execution time increases if limited memory is available.

Action: Increase the memory that is available to the workstation. See Section A.1, Resolving Workstation Memory Problems.

CAPTURE-X-229: The job configuration contains a form that does not exist.

Source: CAPTURE.EXE
Possible Cause: The form specified in the print job configuration might have been deleted.
Action: Modify the print job configuration to specify a form that exists. Or, specify the form on the command line using the Form= command.

CAPTURE-X-906: The Unicode files cannot be found.

Source: CAPTURE.EXE
Action: See message 906: The Unicode files cannot be found.

CAPTURE-X-917: This utility was unable to set the context.

Source: CAPTURE.EXE
Action: See message 917: This utility was unable to set the context..

CAPTURE-X-918: This utility is trying to access an invalid context.

Source: CAPTURE.EXE
Explanation: This error occurs while performing CAPTURE S=server J=job.
Action: Omit S=server or J=job from the command line.

CAPTURE-X-921: Either the supervisor has locked the bindery or volume SYS: is not mounted on server name.

Source: CAPTURE.EXE
Action: See message 921: Either the supervisor has locked the bindery or volume SYS: is not mounted..

CAPTURE-X-922: Intruder detection lockout has disabled this account.

Source: CAPTURE.EXE
Action: See message 922: Intruder detection lockout has disabled this account..

CAPTURE-X-923: An unexpected error has occurred. code

Source: CAPTURE.EXE
Action: See message 923: An unexpected error has occurred. Error code: code..