Novell Doc: Novell ZENworks 7 Handheld Management Administration Guide

D.5 October 7, 2005

Updates were made to the following sections. The changes are explained below.

D.5.1 Using Inventory and Reports

The following changes were made in this section:

Location	Change
Section 5.2, Viewing Hardware Inventory	Added the following note: “For Java-based BlackBerry devices, the Password Enabled field value is not scanned for and the value is always displayed as “No”. The value of Power Save Mode is always “Off”. The serial number is same as the PIN value of the device.”

Location

Change

Added the following note:

“For Java-based BlackBerry devices, the Password Enabled field value is not scanned for and the value is always displayed as “No”. The value of Power Save Mode is always “Off”. The serial number is same as the PIN value of the device.”

D.5.2 Using ZENworks Handheld Management Policies

The following changes were made in this section:

Location	Change
BlackBerry Configuration Policy	Added the following note: “This policy is not supported for Java-based BlackBerry devices.”
BlackBerry Security Policy	Added the following note: “This policy is not supported for Java-based BlackBerry devices.”
Scheduling Packages and Policies	Deleted the following text from the second point, which is one of the considerations that you must ensure if you have configured and enabled policies, but not yet enforced on individual handheld devices: “To change the value, right-click the ZENworks Handheld Management Service object in ConsoleOne, click Properties, in the General page, set the Directory Scan Interval value.”

Location

Change

BlackBerry Configuration Policy

Added the following note:

“This policy is not supported for Java-based BlackBerry devices.”

BlackBerry Security Policy

Added the following note:

“This policy is not supported for Java-based BlackBerry devices.”

Scheduling Packages and Policies

Deleted the following text from the second point, which is one of the considerations that you must ensure if you have configured and enabled policies, but not yet enforced on individual handheld devices:

“To change the value, right-click the ZENworks Handheld Management Service object in ConsoleOne, click Properties, in the General page, set the Directory Scan Interval value.”