The
panel displays the action sets available for the bundle. Depending on the bundle type, the possible action sets are Distribute, Install, Launch, Verify, Uninstall, Terminate, and Preboot. For example, if you select a Windows bundle, five actions sets are available. If you select an Imaging bundle, Preboot is the only available action set available.You can add an action to any of the available action sets. When you do so, that action is performed whenever the action set is applicable. For example, when you add an action to the Install action set, that action is performed whenever the bundle is installed.
You access this dialog box by using the following methods:
As part of the process of creating a Directive bundle by using the Section 2.1, Creating Directive Bundles.
bundle category. For more information, seeIn ZENworks Control Center, click the
tab, click the underlined link of a bundle in the column of the list, click the tab, click one of the action set tabs (Distribute, Install, Launch, Verify, Uninstall, Terminate, or Preboot), click the drop-down list, then select an available action.The following sections contain information about the actions you can configure for the Distribute, Install, Launch, Verify, and Terminate action sets. For more information about the actions you can configure for the Preboot action set, see Preboot Actions
in the ZENworks 10 Configuration Management Preboot Services and Imaging Reference.